To enter the site, you must wear a helmet and use personal protective equipment and electrical safety equipment.
1. When entering the site, you must wear a safety helmet; and properly use personal labor protection products and electrical safety protection products.
2, above 3M high altitude, suspended work, have safety facilities or wear a seat belt, buckle the insurance hook.
3. Scaffolding for working at heights must be firm and reliable, with railings on the sides. The springboards laid on the scaffolding must be strong and the ends must be tied to the scaffolding.
4. When using a ladder, the angle of erection should not be greater than 60° and less than 35°. The upper part of the ladder should be tied to a solid object with a rope. The foot of the ladder should be wrapped with a linen or rubber, or by a special person to support the inpatient department to prevent the ladder from slipping.
5. Tools, parts, etc. used in aerial work should be placed in the tool bag or placed in a proper place. The objects that are transferred up and down are not thrown away. They should be hung or put down on the rope. It is not allowed to throw materials and tools down or up.
6. When laying the cable, there should be a unified command by the person. When the cable is slipped, it is strictly forbidden to move the pulley to prevent crushing. It is necessary to take safety measures such as fire prevention, anti-virus and anti-scalding.
7. For poles, pay-off and tight-line work, special personnel should be assigned to command and unify signals, and roadside safety protection measures should be taken. Staff should not straddle the wires or stand on the inner corner of the wires. It is strictly forbidden to use the method of suddenly cutting the wires. Loose line.
8. It is strictly forbidden to carry out live work. In case of special emergency, reliable safety measures should be taken, and it can only be carried out after approval.
9. The construction site should be neatly cleaned, and all kinds of equipment, materials and waste should be stacked according to the designated location. At the construction site, it walks according to the designated road, can't pass through the dangerous area, can't pass or stay under the lifting object, and pay attention to maintain a certain safe distance from the running machinery.
Before starting work, you should check whether the surrounding environment meets the safety requirements and whether the labor insurance supplies are in good condition. If any factors that threaten safety work are found, they should immediately report to the technical security department or the construction manager. Work can only be done after removing insecurities.
10. When arranging work, try to avoid multiple layers of construction at the same time. If multiple layers must be constructed at the same time, a safety inspection partition or safety net should be installed in the middle layer, and the person working below must wear a safety helmet.
11. When working in a wet place, the voltage of the lighting used should be 12V. When the environment is dry, it cannot exceed 24V.
12. When working in a place with toxic, irritating or corrosive gas or liquid dust, the installer must wear protective equipment such as a mask, glasses or gas mask, in addition to good ventilation or proper dust removal facilities.
13. The operator should know how to prevent electric shock and first aid after electric shock.
Http://news.chinawj.com.cn Submission:Here are all AEG - ATLAS COPCO power tools and the designated carbon brushes,motor brushes, electric brushes, motor brushes, electric motor brushes or simply brushes.
For each power tool, there are usually two carbon brushes to choose from: With automatic stop and without automatic stop. Carbon brushes with automatic stop have a spring through the length of the carbon brush. When the carbon brush wears out, the spring gets released, the current to the carbon brush gets interrupted and your power tools switches off at once. The advantage: No additional wear and tear to your power tool. Carbon brushes without automatic stop do not stop functioning at once, but performance of your power tool will detoriate rapidly. Although handy as a warning sign, this usually isn't very beneficial to your power tool.
Aeg Carbon Brush
Aeg Carbon Brush,Aeg Replacement Carbon Brush,Carbon Brush For Aeg Power Tools
Haimen Hailing Carbon Industry Co., Ltd. , http://www.carbonbrush-hl.com