90° Elbow Copper Press Fittings with ASTM B88

Features and benefits
The original copper press joining solution 
Available in sizes 1/2" to 2", including elbows,couplings,tees,reducer, fitting reducer,caps,
Customizable with three sealing elements, EPDM, HNBR,FKM
leak detection feature identifies un-crimped connections
compatible with most common pressing tools and jaws in the market
All tubing must comply with the ASTM B88 standard
 
 
Operating parameters:
Operating pressure: 200PSI CWP max
Operating temperature range:-20°F-250°F
 
Approved applications 
-Potable water
- Hydronic heating
-Chilled water 
- Compressed air 
-Non-medical gases
-Low pressure steam
 

1. Cut tube square using a tube cutter or fine tooth saw
2. Deburr tube ID using a deburring tool 
3. Deburr tube OD using half round file 
4. Check fittings bead to ensure seal is present. Do not use any type of oil lubrication 
5. Mark tube to proper fitting insertion depth( see insertion depth chart below)

1. Turn slightly while sliding press fitting onto tube. Slide all the way to insertion mark and make contact with stop 
2. Place press tool at a right angle over fitting bead .Start the pressing process. Please see specific tool manufacturer for tool instruction 

Features and benefits
The original copper press joining solution 
Available in sizes 1/2" to 2", including elbows,couplings,tees,reducer, fitting reducer,caps,
Customizable with three sealing elements, EPDM, HNBR,FKM
leak detection feature identifies un-crimped connections
compatible with most common pressing tools and jaws in the market
All tubing must comply with the ASTM B88 standard
 
 
Operating parameters:
Operating pressure: 200PSI CWP max
Operating temperature range:-20°F-250°F
 
Approved applications 
-Potable water
- Hydronic heating
-Chilled water 
- Compressed air 
-Non-medical gases
-Low pressure steam
 

1. Cut tube square using a tube cutter or fine tooth saw
2. Deburr tube ID using a deburring tool 
3. Deburr tube OD using half round file 
4. Check fittings bead to ensure seal is present. Do not use any type of oil lubrication 
5. Mark tube to proper fitting insertion depth( see insertion depth chart below)

1. Turn slightly while sliding press fitting onto tube. Slide all the way to insertion mark and make contact with stop 
2. Place press tool at a right angle over fitting bead .Start the pressing process. Please see specific tool manufacturer for tool instruction